Calibration
...
Automated signal detection
Place flags into the dip before each systolic peak, wherever missing.
Analysis → find cycle
Peaks/Events:
Select Event
Start event: Flag; CH5, CNAP Blood Pressure
End event: Flag; CH5, CNAP Blood Pressure
Selection:
Select are around flags where the dips are included
Output:
Output events check
Event 1: Minimum
Input and output channel: CH5 CNAP Blood Pressure
Output type: Hemodynamics → Diastole
Clear flag events
Right-click on any event → edit event → clear → are of type flag → on CH5 CNAP Blood Pressure → ok → cannot be undone ok
Inspect the entire signal again
Check for markers that are
Missing
Duplicates
In the wrong place
Sitting on top of each other: you can toggle through the Event list under right-click → edit event to check for this